Hello Guest!
Your Cart

BrightLine FLEX System - Flat Cap Front

In stock
SKU
flatcapfront

SKU: flatcapfront

$24.95
The FLAT CAP FRONT zips onto the FRONT side of any module to serve as the starting point of any bag.

The FLAT CAP FRONT is designed for those users that do not need all the additonal small pockets that are offered with the Pocket Cap Front but need a starting point for the front side of their bag.

The FLAT CAP FRONT module offers two flat pockets on the outside, and one flat half-height slip pocket on the inner surface of the module. The primary outer pocket is accessed from the top and has a cover flap that is secured with Velcro. This where you'll likely store your iPad (as long as it's not in a thick case), or a manilla folder or two for some documents, or a magazine.

There is a second flat half-height panel on the outside surface of the first one, that has a zipper across the very bottom. If the zipper is closed then this half-height panel acts like a pocket. If the zipper is open then the opening at the bottom allows the telescoping tubes of a suitcase or folding cart to pass through and the panel serves to secure your bag to those tubes (especially when this FLAT CAP FRONT is attached to other modules to form bigger bags like the B2 COMPUTE, B4 SWIFT or the B7 FLIGHT.

There is also a flat half-height slip pocket on the inner surface of the module. It has a cover flap secured with a spot of Velcro. Here you can stow an important document or two, or any small flat item that you'd like to keep out of harm's way. NOTE: The FLAT CAP FRONT is one-directional (as are ALL of the FLEX System modules). It is always FRONT-facing. That means that it can only be zipped onto the FRONT SURFACE of any module. You cannot zip a FLAT CAP FRONT onto both the front and the rear of a center section.
Write Your Own Review
You're reviewing:BrightLine FLEX System - Flat Cap Front